1. Wood circles sizes used are as follows: 4 in, 6.5 in, 8 in, and 10 inch. Similar wood circles can be found at craft stores as well.
2. Acrylic craft paint in several colors (up to five)
3. paint brushes
4. blue painter's tape
5. 1/2" thick dowel rods
6. Rotary tool or small saw (to cut the dowels)
7. Wood glue
8. Sheet of 1/8" - 1/4" hardboard or plywood
9. Hammer and nails
10. Saw tooth picture hanger
How-To:
1. Start by taping off various shapes on one of the wood circles. Be sure to press the tape down securely, especially at the edges, for a crisp line when finished.
2. Paint inside the taped off area, and allow to dry.
3. Remove painter's tape and begin the process again with another color. Or keep it simple, and use only one color. Or use three! Have fun with it.
4. Repeat this process for all of your circles in various sizes, and be sure to mix up the patterns and color combos.
5. Now, it's time to cut some dowels. Using a rotary tool or saw, cut various lengths from the dowels (I stuck to four different sizes for this project - one short, one medium-short, one medium, and one tall). The dowels will determine how far away each circle will rest from the main wood frame that everything is connected to. NOTE: I also attached several circles straight to the wood panel base, without any dowels, which gave me a fifth height.
6. Once the dowels have been cut, set aside and do a dry fit to roughly map out the positioning for where you want the painted circles to line up when everything comes together. Once you start putting everything together, this layout might change, but it's good to have a game plan when you get started.
7. With the design in place, it's time to start gluing the dowels to the back of each circle. Flip over all of your circles and using wood glue, attach a dowel to the center of each circle and let them dry according to the instructions on the glue bottle. Clamp if necessary for thirty minutes to an hour and do not stress joints for a full 24 hours. You can also use the painter's tape to hold things in place while the glue dries. NOTE: I selected the dowel heights at random, for the most part, making sure that no two circles next to each other would be at the same height.
8. Next attach a saw tooth hanger to the upper center of the hardboard or wood base. Flip over.
9. Now, that you have given the dowels enough time to fully dry and attach securely to the circles, you are ready to attach the dowels to the wood base with more wood glue. Additionally, nails can be hammered through the underside of the wood base and into the dowels for extra security. This helps keep the dowels in place while the glue is drying, in addition to extra security, but is not required.
9. Allow the entire piece to dry for a full 24 hours before hanging.
This was one of the easy DIYs for home decor, there are many more coming so stay tuned! :)
0 comments:
Post a Comment